Audio-Technica stylus for Audio-Technica AT-31E AT31E cartridge

Audio-Technica stylus for Audio-Technica AT-31E AT31E cartridge

SKU: ATSAT0031E

  • $179.95

AUDIO-TECHNICA STYLUS FOR AUDIO-TECHNICA AT-31E AT31E CARTRIDGE

The Audio-Technica ATN-31E ATN31E needle stylus for the highly regarded low-output moving coil Audio-Technica AT-31E AT31E phono cartridge features a nude elliptical diamond with a .0003 x .0007 inch scanning radii. It offers superb tracing of record grooves, long playing life and excellent reproduction and rendition of voice, music and harmonics. The stylus assembly may be disconnected and replaced more than 2,000 times with no appreciable increase in output noise. The stylus is made in Japan by Audio-Technica.

Audio-Technica ATN31E Stylus Specifications
- Frequency response: 15Hz-50kHz
- Output voltage @ 1kHz, 5 cm/sec: 0.4mV
- Channel separation @ 1kHz: Minimum 30dB
- Channel balance @ 1kHz: Within 1.0dB
- Tracking force: 1.2 - 1.8 g (Nominal force 1.5 g)
- Dynamic compliance: 8.5 x 10-6 cm/dyne (100 Hz)
- Static compliance: 32 x 10-6 cm/dyne
- Load resistance: More than 10 ohms
- Load capacitance: 100 - 200 pf
- Stylus: 0.15 mm nude square, 0.3 x 0.7 mil elliptical diamond


JOIN OUR NEWSLETTER

Stay in the loop with LP Tunes sales, promotions & deals!

★ Reviews ★

Let customers speak for us

7 reviews
100%
(7)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
Great Service

Quick, responsive and accurate service. I will definitely order from LP Tunes again.

5/5

Crosley CR-6249 turntable belt replacement

This is great sounding stylus!

Great service and help! Thanks

Huge improvement

Have been listening to the stylus for two hours and am delighted with the results - significant gains in clarity and transparency.

Stanton 681eee Vivid Line

I have been using this on my Stanton 680 cartridge with great success. Very smooth and articulate. This stylus is much better than the generic .2 x.7 stylus I was using. Alignment was slightly difficult but a small bubble level helped. Why Stanton/Pickering made a cartridge body with thin metal screw mounts is a puzzle. You have to make sure the cartridge is perpendicular to the record surface. Over the years I have seen some cartridges with a tilt between the body and mount. I am sure the LPTunes Shibata stylus for the Stanton 680/681 would sound better, but for my use the Vivid Line stylus is more than adequate